Spa Hot Tub Pump 1.5HP Full Rated 1 1/2" with Pre-Installed "Thermal Wrap Heater Jacket. For spas and hot tubs requiring 1 speed motors. Note: Typically this pump and motor is used on hot tubs requiring a 230 volt motor even though it's dual voltage. For hot tubs requiring a 115 volt motor rated at 1.5HP, we recommend our single voltage motor. Motor Description: Mfg: Century HP: 1.5 - Service factor 1.0 (2hp SPL) RPM: 3450 Single Speed 115/230 Volts - dual voltage Amps: 16.5/8.3 HZ: 60 Frame: 56Z (48Y) Thermally Protected.Pump Description: Mfg: Vico/Balboa P/N. PKUL15SDCS, 5190-240, PKUL15HSDCS 1.5 HP (2HP SPL) 1 1/2" Center Suction x Side Discharge (2" Connections available) 48 Frame.
Great Value - Direct From The Manufacture of the patented Thermal Wrap - Heat Recycling System. Ultra Jet Spa Pump With Thermal Wrap (Heat Transfer/Recycling System). For more information on the "Thermal Wrap" Heat Jacket.
It's like free heat! Can be used and retrofitted to work with most spas requiring 1.5 hp single speed, 3450 rpm, 115/230 volts pump motor. Note: Before ordering this "FULL RATED" 1.5 hp - as a replacement pump - make sure that your existing pump is not an "Uprated" pump.Sometimes manufactures call their pump a 1.5 HP when it's really 1 hp. They call this an Uprated or SPL Pump. The motor amperage determines the true horse power.
A 1 hp pump will be rated at approximately 11-14 amps. A 1.5 hp pump will be rated approximately 15 - 16 amps. Also note: you may think you have or need a pump for 2" plumbing, when you actually need 1 1/2".
The pump connections measure larger than the actual pipe size used. The threaded connection on a 1 1/2" pump measure 2 3/8" - the threaded connections on a 2" pump measure 3". Unless otherwise specified, you will receive 1 1/2 pump connections. More about the - Thermal Wrap - Heat Transfer System. Tub water circulates through a serpentine path in the Thermal Wrap, collecting the heat generated by the pump/motor and recycles that heat to the tub water - were it belongs!
This patented heating system for hot tubs/spas and Whirlpool Baths, captures and recycles the waste heat "energy" produced by the pump/motor and delivers that heat to the hot tub or bath water. The Thermal Wrap system will heat and maintain water temperature. The system allows the motor to run cooler; increasing the motors longevity and efficiency.
There are no moving parts and nothing to wear out. Patented design, over 1,000,000 in use.Special thermal conductive inner heat transfer liner. Models available for most 48 frame thru bolt spa/hot tub and jetted bathtub pump motors. Maintenance free - no moving parts to wear out. Helps keep motor cooler - increases motor longevity and efficiency.
Cost less than electric heaters. No additional electrical circuits required for installation.
Self draining design (required for whirlpool bath application). The Thermal Wrap will help maintain water temperature during normal filtering and heating cycles and while using your spa in high speed jet action.Note: Thermal Wrap color may vary. The item "Hot Tub Pump 1.5hp (Full Rated) 1 1/2 Ultra Jet with Thermal Wrap Heat Jacket" is in sale since Thursday, February 27, 2014. This item is in the category "Home & Garden\Yard, Garden & Outdoor Living\Pools & Spas\Spas & Hot Tubs". The seller is "jkc0853" and is located in Houston, Texas. This item can be shipped to United States, Canada.